D-Link DWS-3000 Series

Unified Switch Channel and Power Commands 153
4 Wireless Commands
Channel Plan The channel plan type or mode, managed AP radios operating in the specified
mode will be considered for this channel plan.
Channel Plan Mode The frequency for automatic channel planning manual, fixed time, or
interval. If the mode is manual, the channel algorithm will not run unless you
request it.
Channel Plan Interval If the channel plan mode is interval, this indicates the frequency in
hours that the channel plan is computed and applied .
Channel Plan Fixed Time If the channel plan mode is fixed time, this indicates the time (24-
hour time) at which the channel plan is computed and applied.
Channel Plan History Depth This indicates the number of iterations of the channel plan that
are maintained in the channel plan history. The channel on a managed AP
radio will not be changed more than once within the channel plan history.
show wireless channel-plan history
This command displays a history for the automatic channel algorithm. The channel plan type
argument must be specified. A channel history is maintained separately for each radio
frequency. The channel algorithm maintains a configured number of iterations of applied
channel changes to avoid frequent channel changes to the same managed AP radio.
Format
show wireless channel-plan history {a | bg}
Mode Privileged EXEC
a Configure channel plan mode for 802.11a.
bg Configure channel plan mode for 802.11b/g.
Current Iteration Indicates the current iteration of the channel plan.
Operational Status Indicates whether automatic channel planning is active or inactive. Auto-
matic channel planning may be inactive due to 802.11h or unsupported clear
channels.
Last Algorithm Time Indicates the last time the channel planning algorithm completed.
AP MAC address The managed AP Ethernet MAC address.
Location A descriptive location string configured for the managed AP.
Radio The radio interface on the managed AP.
Iteration
Iteration of the channel plan where the new channel was computed and applied.
Channel The channel computed and applied to the managed AP.
show wireless channel-plan proposed
This command displays the proposed channel plan changes for a manual request to run the
channel algorithm. The channel plan type argument must be specified. The channel algorithm
is run separately for each radio frequency. The proposed channel changes may be cleared or
applied using the wireless channel-plan command.
Format
show wireless channel-plan proposed {a | bg}