156 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
mode (AP Config Mode)
This command configures the managed mode for an AP.
Default ws-managed
Format
mode {ws-managed | standalone | ack-rogue}
Mode AP Config
ws-managed AP is managed by the Unified Switch upon discovery.
standalone AP is managed as a standalone AP and should not be reported as rogue by the
Unified Switch.
ack-rogue AP is known on the network and should not be reported as rogue by the Uni-
fied Switch.
location
This command configures a descriptive string for the AP location.
Format
location <value>
Mode AP Config
value This parameter is an AP location string. It should not be more than 32 charac-
ters long. To use spaces in the location, enclose the value with quotes, for
example “Conference Room A.”
no location
The no version of this command deletes the current location string for the AP.
Format
no location
Mode AP Config
password (AP Config Mode)
This command configures the password that this AP must use to authenticate to the Unified
Switch. The password is only verified if global AP authentication is enabled. After you enter
the password, the CLI prompts you to enter a password that is between 8-63 alphanumeric
characters.
Default The default password is blank.
Format
password
Mode AP Config
no password
The no version of this command deletes the password for the AP.
Format
no password
To Next Page
Loading...
Need help?
General
