Captive Portal Local User Commands 223
4 Wireless Commands
user rate-limit total-octets
Use this command to limit the number of bytes the user is allowed to transmit and receive. The
maximum number of octets is the sum of octets transmitted and received. After this limit has
been reached, the user will be disconnected. 0 octets denote unlimited transmission. The
<user-id> variable is the user ID, which can be from 1 to 128 alphanumeric characters. The
<octets> variable is the number of bytes.
Default 0
Format
user <user-id> rate-limit total-octets <octets>
Mode Captive Portal Config Mode
Example:
The following shows an example of the command.
(Switch)(Config-CP) #user 1 rate-limit total-octets 100<cr>
no user rate-limit total-octets
This command sets the user rate-limit total-octets to the default value.
Format
no user <user-id> rate-limit total-octets
Mode Captive Portal Config Mode
Example:
The following shows an example of the command.
(Switch)(Config-CP) #no user 1 rate-limit total-octets<cr>
show captive-portal user
This command displays all configured users or a specific user in the captive portal local user
database. Enter the optional username to view information about the specified user. The
[user-name] variable is a valid user configured in the local database.
Format
show captive-portal user [user-name]
Mode Privileged EXEC
User Displays the user name
Group Displays the group to which the user belongs
Session Timeout Displays the number of seconds
Idle Timeout Displays the number of seconds
When you specify a user with the optional
[user-name] variable, the following information
displays:
User Displays the user name
Password Configured. Indicates whether a password is configured for the user
Group Name Displays the group to which the user belongs
To Next Page
Loading...
