D-Link DWS-3000 Series

Captive Portal Configuration Commands 209
4 Wireless Commands
Default 0
Format
rate-limit up <rate>
Mode Captive Portal Instance Mode
Rate Rate in bps. 0 indicates the limit is not enforced.
Example:
The following shows an example of the command.
(Switch)(Config-CP) #rate-limit up 100<cr>
no rate-limit up
Use this command to set the rate-limit up to the default value.
Format
no rate-limit up
Mode Captive Portal Instance Mode
Example:
The following shows an example of the command.
(Switch)(Config-CP) #no rate-limit up<cr>
rate-limit down
Use this command to configure the maximum rate at which a client can receive data from the
network.
Default 0
Format
rate-limit down <rate>
Mode Captive Portal Instance Mode
Rate Rate in bps. 0 indicates the limit is not enforced.
Example:
The following shows an example of the command.
(Switch)(Config-CP) #rate-limit down 100<cr>
no rate-limit down
Use this command to set the rate-limit down to the default value.
Format
no rate-limit down
Mode Captive Portal Instance Mode
Example:
The following shows an example of the command.
(Switch)(Config-CP) #no rate-limit up<cr>
rate-limit input-octets
Use this command to configure the maximum number of octets the user is allowed to transmit.
After this limit has been reached, the user will be disconnected. If the value is set to 0, then the
limit is not enforced.