166 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
wpa2 key-caching holdtime
This command configures the length of time a PMK will be cached by an AP for either client
roaming or key forwarding.
Default 10
Format
wpa2 key-caching holdtime <0-1440>
Mode Network Config
0-1440
WPA2 key caching hold time in minutes.
no wpa2 key-caching holdtime
The no version of this command sets the WPA2 key caching hold time to its default value.
Format
no wpa2 key-caching holdtime
Mode Network Config
wep key
This command configures up to 4 static WEP keys for the network. The configured keys are
used when the network security mode is set to WEP shared key, according to the configured
WEP transfer key index. The number of characters required depends on the configured WEP
key type and length.
Format
wep key <1-4> <value>
Mode Network Config
1-4 A valid WEP key index
value The WEP key itself, entered in ASCII or HEX format. The following list
shows the number of keys to enter in the field:
64 bit —ASCII: 5 characters; Hex: 10 characters
128 bit —ASCII: 13 characters; Hex: 26 characters
152 bit —ASCII: 16 characters; Hex: 32 characters. For more information,
please see the “Static WEP” table in the D-Link Unified Wired/Wireless
Access System WLAN Switching Administrator’s Guide.
no wep key
The no version of this command removes the corresponding WEP key configuration.
Format
no wep key <1-4>
Mode Network Config
wep key type
This command configures the WEP key type for the network. The configured key type is used
when the network security mode is set to WEP shared key. The WEP key type affects the
To Next Page
Loading...
