D-Link DWS-3000 Series

Port-Channel/LAG (802.3ad) Commands 89
2 Switching Commands
port-channel
This command configures a new port-channel (LAG) and generates a logical slot/port number
for the port-channel. The
<name> field is a character string which allows the dash “-” character
as well as alphanumeric characters. Use the
show port channel command to display the slot/
port number for the logical interface.
NOTE: Before you include a port in a port-channel, set the port physical mode. For
more information, see “speed” on page 40.
Format
port-channel <name>
Mode Global Config
no port-channel
This command deletes a port-channel (LAG).
Format
no port-channel {<logical slot/port> | all}
Mode Global Config
addport
This command adds one port to the port-channel (LAG). The first interface is a logical slot/
port number of a configured port-channel.
NOTE: Before adding a port to a port-channel, set the physical mode of the port. For
more information, see “speed” on page 40.
Format
addport <logical slot/port>
Mode Interface Config
deleteport (Interface Config)
This command deletes the port from the port-channel (LAG). The interface is a logical slot/
port number of a configured port-channel.
Format
deleteport <logical slot/port>
Mode Interface Config
deleteport (Global Config)
This command deletes all configured ports from the port-channel (LAG). The interface is a
logical slot/port number of a configured port-channel. To clear the port channels, see “clear
port-channel” on page 273
Format
deleteport {<logical slot/port> | all}
Mode Global Config