Access Point Profile Commands 169
4 Wireless Commands
WPA2 Key Forwarding Mode If WPA2 encryption is enabled, indicates Dynamic Key For-
warding support for roaming WPA2 clients.
WPA2 Key Caching Holdtime Length of time a PMK will be cached by an AP after the cli-
ent using this PMK has roamed away from this AP.
Access Point Profile Commands
The commands in this section provide configuration of access point profiles. Access point
profiles can be applied to multiple physical APs.
ap profile
This command adds an AP profile (if not already present) and enters the AP profile
configuration mode. In this mode, you can modify the profile configuration parameters. You
can modify an AP profile at any time. If the profile is associated with one or more Managed
APs, you must use the
wireless ap profile apply command to send the changes to those
APs.
Default 1 - Default
Format
ap profile <1-16>
Mode Wireless Config
1-16 Identifier for the AP Profile
no ap profile
The no version of this command deletes a configured AP profile. If the profile is referenced
by an entry in the valid AP database, or is applied to one or more managed APs, it cannot be
deleted. The default profile (1 – Default) can never be deleted.
Format
no ap profile <1-16>
Mode Wireless Config
1-16 Identifier for the AP Profile
name
This command allows you to configure a descriptive name for the AP Profile.
Default Default (AP profile 1)
Format
name <name>
Mode AP Profile Config
name AP Profile name; it must be less than 32 characters. Use quotes around a name
that contains spaces.
To Next Page
Loading...
