Wireless Network Commands 163
4 Wireless Commands
no wpa versions
The no version of this command configures the supported WPA versions to the default value.
Format
no wpa versions
Mode Network Config
wpa ciphers
This command configures the WPA cipher suites supported on the network; one or both
parameters must be specified. This configuration only applies when the configured security
mode is WPA.
Default tkip
Format
wpa ciphers {ccmp [tkip] | tkip}
Mode Network Config
tkip TKIP encryption.
ccmp CCMP encryption.
no wpa ciphers
The no version of this command WPA returns supported cipher suites to the default value.
Format
no wpa ciphers
Mode Network Config
wpa key
This command configures the WPA shared key. This is an alphanumeric string in the range
8-64 characters. The configured key is used when the network security mode is set to WPA
shared key.
Default None
Format
wpa key <value>
Mode Network Config
tunnel
This command enables client traffic tunneling on the network. For the tunnel to be
operational, global routing must be enabled on the switch and the tunnel subnet, and mask
must be configured and match a valid routing interface.
Default Disable
Format
tunnel
Mode Network Config
To Next Page
Loading...
