62 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
Acceptable Frame Types The types of frames that may be received on this port. The options
are 'VLAN only' and 'Admit All'. When set to 'VLAN only', untagged frames
or priority tagged frames received on this port are discarded. When set to
'Admit All', untagged frames or priority tagged frames received on this port
are accepted and assigned the value of the Port VLAN ID for this port. With
either option, VLAN tagged frames are forwarded in accordance to the
802.1Q VLAN specification.
Ingress Filtering May be enabled or disabled. When enabled, the frame is discarded if this
port is not a member of the VLAN with which this frame is associated. In a
tagged frame, the VLAN is identified by the VLAN ID in the tag. In an
untagged frame, the VLAN is the Port VLAN ID specified for the port that
received this frame. When disabled, all frames are forwarded in accordance
with the 802.1Q VLAN bridge specification. The factory default is disabled.
GVRP May be enabled or disabled.
Default Priority The 802.1p priority assigned to tagged packets arriving on the port.
show vlan association subnet
This command displays the VLAN associated with a specific configured IP-Address and net
mask. If no IP address and net mask are specified, the VLAN associations of all the configured
IP-subnets are displayed.
Format
show vlan association subnet [<ipaddr> <netmask>]
Mode Privileged EXEC
IP Address The IP address assigned to each interface.
Net Mask The subnet mask
VLAN ID There is a VLAN Identifier (VID) associated with each VLAN.
show vlan association mac
This command displays the VLAN associated with a specific configured MAC address. If no
MAC address is specified, the VLAN associations of all the configured MAC addresses are
displayed.
Format
show vlan association mac [<macaddr>]
Mode Privileged EXEC
Mac Address
A MAC address for which the switch has forwarding and or filtering
information. The format is 6 or 8 two-digit hexadecimal numbers that
are separated by colons, for example 01:23:45:67:89:AB. In an IVL
system the MAC address will be displayed as 8 bytes.
VLAN ID There is a VLAN Identifier (VID) associated with each VLAN.
Double VLAN Commands
This section describes the commands you use to configure double VLAN (DVLAN). Double
VLAN tagging is a way to pass VLAN traffic from one customer domain to another through a
To Next Page
Loading...
