Network Interface Commands 293
7
Management Commands
This chapter describes the management commands available in the D-Link Unified Wired/
Wireless Access System CLI.
The Management Commands chapter contains the following sections:
• “Network Interface Commands” on page 293
• “Console Port Access Commands” on page 297
• “Telnet Commands” on page 298
• “Secure Shell (SSH) Command” on page 302
• “Hypertext Transfer Protocol (HTTP) Commands” on page 304
• “Access Commands” on page 306
• “User Account Commands” on page 306
• “SNMP Commands” on page 309
• “RADIUS Commands” on page 318
• “TACACS+ Commands” on page 324
• “Configuration Scripting Commands” on page 326
• “Pre-login Banner and System Prompt Commands” on page 328
The commands in this chapter are divided into three functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every configu-
ration command, there is a show command that displays the configuration setting.
• Copy commands transfer or save configuration and informational files to and from the
switch.
Network Interface Commands
This section describes the commands you use to configure a logical interface for management
access. To configure the management VLAN, see “network mgmt_vlan” on page 53
enable (Privileged EXEC access)
This command gives you access to the Privileged EXEC mode. From the Privileged EXEC
mode, you can configure the network interface.
Format
enable
To Next Page
Loading...
