SOFTWARE CONFIGURATION
172
MATRIX 220
Diagnostic Alarms
Diagnostic error messages are sent to the BM150 display as numeric Alarm Codes, (even
if Failure Messages are selected for data transmission the numeric Alarm Code is sent to
the display).
X = numeric Alarm Code (see below for the list of Alarm Codes)
R = Device Network Type – MUL=Multidata, S
YN=Synchronized, ALN=Alone
N = Device Network Setting – M00=ID-NET Network Master, Sxx= ID-NET Network Slave
address, Null st
ring= Alone (no network)
Alarm Code Description
1 Slave No Reply
64 Slave Address Duplication
171 Protocol Index Failure
185 Backup Memory Communication Failure
187 Wrong Rotary Switch Selection
189 Fieldbus Communication Failure
191 Fieldbus Type Mismatch
193 Fieldbus Configuration Error
195 Fieldbus DHCP Problem
201 No XRF Slave(s) Detected
Slave Node Alarms (Master only)
X = slave node number (1-31)
R = Device Network Type – MUL=Multidata, S
YN=Synchronized
To Next Page
Loading...
Need help?
General
