Datalogic Matrix 300N - FCC Compliance; EAC Compliance; LED Safety; Laser Safety

Compliance
x Matrix 300N
systems. For this reason it is under the responsibility of the system integrator to
perform a new risk assessment regarding the final installation.
Warning
This is a Class A product. In a domestic
environment this product may cause
radio interference, in which case the user may be required to take adequate
measures.
FCC Compliance
Modifications or changes to this equipment without the expressed written
approval of Datalogic could void the authority to use the equipment.
This device complies with PART 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested
and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference when the equip-
ment is operated in a commercial environment. This equipment generates, uses,
an
d can radiate radio frequency energy and, if not installed and used in accor-
dance with the instruction manual, may cause harmful interference to radio
c
ommunications. Operation of this equipment in a residential area is likely to
cause harmful interference, in which case the user will be required to correct the
interference at his/her own expense.
EAC Compliance
Customs Union:
The CU Conformity certification has been a
chieved; this allows the Product to
bear the Eurasian Mark of conformity.
LED Safety
LED emission according to EN 62471.
Laser Safety
The Matrix 300N internal illuminators contain two aiming Laser LEDs used to
position the reader.
This product conforms to the applicable requirements of IEC 60825-1 and com-
plies with 21 CFR 1040.10 except for deviations pursuant to Laser Notice N° 50,
da
te June 24, 2007. This product is classified as a Class 2 laser product accord-
ing to IEC 60825-1 regulations.
WARNING
Use of controls or adjustments or performance of procedures other than those speci-
fied herein may result in exposure to hazardous visible laser light.