Software Configuration
178
Matrix 300N
Restore Factory Defaults
In order to return a device to its absolute Factory default parameters (for
example device replacement) it is necessary to use the Restore Factory Defaults
command. You will be prompted to confirm.
All Environment parameters will be restored to Factory default values and any
e
xisting configurations stored on the device will be erased. The device will be
reset and therefore start in run mode with the factory default configuration.
Diagnostic Alarms
By using the DL.CODE Monitor functions from the File menu (or Monitor icon),
you can get information about the state of the ID-NET network.
Figure 94 - Diagnostic Alarms
To Next Page
Loading...
