Product Reference Guide 1
Chapter 1
Rapid Configuration
Step 1 - Connect the System
To connect the system in a Stand Alone configuration, you need the hardware
indicated in
Figure 1. In this layout the data is transmitted to the Host on the
main serial interface. Data can also be transmitted on the RS232 auxiliary
interface irrespective of the main interface selection.
When One Shot or Phase Mode Operating mode is used, the reader is activated
by
an External Trigger (photoelectric sensor) when the object enters its reading
zone.
Host
Main Serial Interface (RS232 or RS422 Full-Duplex
External Trigger (for One Shot or Phase Mode)
PG6000
CAB-DSxx-S
Matrix 300N
CBX
I/O, Aux
Figure 1 - Matrix 300N in Stand Alone Layout
To Next Page
Loading...
