Datalogic Matrix 300N - Ethernet Connection

Ethernet Connection
Product Reference Guide 85
Ethernet Connection
The Ethernet connection is possible in two different layouts.
In a Point-to-Point layout the reader is connected to a local host by using a CAB-
ETH
-M0x cable. There is no need to use a crossover adapter since Matrix 300N
incorporates an autocross function.
PG6000
Host
CAB-DSxx-S
Matrix 300N
CAB-ETH-M0x
CBX



Ethernet Interface
Auxiliary Serial Interface (RS232 - Data Monitor)
External Trigger (for One Shot or Phase Mode)
Alone



Figure 60 - Ethernet Point-to-Point Layout
All devices always support multiple output channels (i.e. for data monitoring).