Datalogic Matrix 300N - Learn

Step 4 - X-PRESS Configuration
Product Reference Guide 7
Learn
Figure 7 - X-PRESS Interface:
Learn Function
6. Enter the Learn function by pressing and
holding the X-PRESS push button until
the Learn LED is on.
7. Release the button to enter the Learn
function. The Learn LED will blink until
the procedure is completed.
The Learn procedure ends when the
Image Processing and Decoding parame-
ters for a single code are successfully
saved in the reader memory, the Green
Spot is activated, the Learn LED will stop
blinking and Matrix 300N emits 3 high
pitched beeps
1
.
If the autolearning cannot be reached after a
timeout of about 3 (three) minutes, Matrix
300N will exit without saving the parameters
to memory, the Learn LED will stop blinking
and in this case Matrix 300N emits a long low
pitched beep.
1. The Code Autolearn procedure will not recog-
nize the following symbologies: Postal Codes,
Pharmacode, MSI, Standard 2 of 5, Matrix 2 of 5.
NOTE
NOTE
NOTE
NOTE
The Grade A Barcode Test Chart cannot be used to set the Code 128 symbology (even
though the reader successfully reads the code). Use the application specific code if
you need to set this symbology.
When using X-PRESS or the BM150 menu to perform Auto-Learn, only a single code
can be configured (successive Learns will substitute the current code). To configure
multiple codes, use the DL.CODE Auto-Learn procedure.
You can always exit from any X-PRESS function at any time by pressing the X-PRESS
push button once. After a short delay the procedure is canceled.
If you have used this procedure to configure
Matrix 300N, go to step 7.