Datalogic Matrix 300N - Fieldbus Connection

Typical Layouts
88 Matrix 300N
Fieldbus Connection
In this layout a single reader functions as a Slave node on a Fieldbus network.
The data is transmitted to the Host through an accessory Fieldbus interface
board installed inside the CBX500 connection box.
Reader configuration can be accomplished th
rough the Ethernet interface using
the DL.CODE configuration program.
Data can be transmitted on the RS232 auxi
liary interface irrespective of the
Fieldbus interface selection to monitor data.
When One Shot or Phase Mode operating mode is used, the reader can be acti-
vated by an External Trigger (photoelectric sensor) when the object enters its
re
ading zone.
Host
CAB-DSxx-S
Matrix 300N
CBX500



Fieldbus Interface (Profibus, DeviceNet, etc.)
Auxiliary Serial Interface (RS232 - Data Monitor)
External Trigger (for One Shot or Phase Mode)
Alone



Power
Figure 64 - Fieldbus Interface Point-to-Point Layout
All devices always support multiple output channels (i.e. for data monitoring).