84
Matrix 300N
Chapter 5
Typical Layouts
The following typical layouts refer to system hardware configurations. However,
they also require the correct setup of the software configuration parameters.
Dotted lines in the figures refer to optional hardware configurations within the
particular layout.
NOTE
NOTE
NOTE
All software configurations are made through DL.CODE which connects to the reader
through the on-board Ethernet interface.
DL.CODE now supports several different multi devi
ce configuration types using the
PASS-THROUGH configuration. In particular this feature allows MULTIDATA ID-NET
network configurations to be made. Master/Slave SYNCHRONIZED ID-NET network
configurations are also configurable as before.
The Master/Slave Role is only significant for the Internal ID-NET N
etwork. If your lay-
out doesn’t use the ID-NET network then the device Role is not significant and can be
ignored.
To Next Page
Loading...
