Step 6 - Device Configuration
Product Reference Guide 13
Step 6 - Device Configuration
Automatic or Advanced Setup
Automatic Setup provides an automatic procedure for setting: optical/
illumination, reading distance (for software adjustable focus liquid lens models),
and code definition parameters to obtain the most stable decoding conditions
for a single code symbology based on the images presented to the reader. It can
be set to include Image Filters if necessary. See the table below for codes and
filters managed by Automatic Setup. Automatic Setup is especially useful for
DPM applications.
Enabled 1D Codes Enabled 2D Codes Enabled Filters
CODE 128
EAN 128
CODE 39
CODE 93
CODABAR
PDF417
MICRO PDF417
GS1 DATABAR
GS1 DATABAR STACKED
GS1 DATABAR LIMITED
GS1 DATABAR EXPANDED
GS1 DATABAR EXPANDED STACKED
UPCEAN FAMILY EAN13
UPCEAN FAMILY EAN8
UPCEAN FAMILY UPCA
UPCEAN FAMILY UPCE
DATAMATRIX ECC 200
QR
MICRO QR
AZTEC
MAXICODE
DOTCODE
ERODE 3x3, 5x5 and 7x7
DILATE 3x3, 5x5 and 7x7
SMOOTHING
Advanced Setup provides access to the complete array of optical/illumination,
software and manual focusing adjustment, and code definition parameters that can
be fine-tuned semi-automatically and manually to obtain the best results for
applications of any complexity.
NOTE
If your application requires multiple code symbologies, multiple image settings, Code
Grading or other parameter settings for decoding, then use the Advanced Setup, see
Advanced Setup for Software Adjustable Focus Models (Liquid Lens).
To Next Page
Loading...
