Software Configuration
180
Matrix 300N
BM150 Display Module Configuration and Messages
The BM150 display module is an optional accessory for the CBX500 connection
box. Although independent, it is an extension of the reader's HMI Interface, so
through its keypad it provides execution of HMI features such as Test, Focus/
Locate, Calibration and Code Setting. It also displays device status information,
reading results, diagnostic and network messages. Since it connects through the
BM100 backup memory module, it provides access to Backup and Restore
features through its Extended menu.
Configuration Through DL.CODE
BM150 must be detected through the BM100 backup memory module at power-
up/reset and this is done through a command setting in DL.CODE. By connecting
the reader to DL.CODE the following parameters can be managed.
In the Device>Settings>Settings>Maintenance window:
• Enable BM100 Detection
Checked (Enabled): the BM100 backup me
mory module will be detected on
power-up/reset; therefore the BM150 display module (if present), will also
be enabled.
Unchecked (Disabled): the BM100 bac
kup memory module will not be
detected on power-up/reset; therefore the BM150 display module (if
present), will also not be enabled.
• BM150 Display Layout (Master Only)
Reading Mask Only: the Reading Mask scree
n is sent to the BM150 display.
Reading Mask/Device State: the Reading Mask/Device State screen is sent to
th
e BM150 display.
Accessing the HMI Interface Through Keypad and Display Menu
Through its keypad and display, the BM150 provides a remote extension of the
reader's HMI Interface. The HMI default menu items can be accessed as well as
the View menu for Master devices and the Extended menu for Backup and
Restore functions.
Up Enter Down
Figure 87 - BM150 Keypad
To Next Page
Loading...
