Datalogic Matrix 300N User Manual

Backup and Restore Through DL.CODE
Product Reference Guide 175
Replacement
CAUTION
The Restore function also provides easy and secure Single Device Replacement:
1. Remove the device t
o be replaced.
2. Connect the new device (make sure the new device has been previously set
to
factory default).
3. Run the Restore procedure by selecting either Sin
gle Reader Restore (from
file on PC) or Restore from external storage device item (see: Restore pro-
cedure).
NOTE
The replacement device must be the exact same model as the device it is replacing.
In case of Backup or Restore operation fail
ures, error messages will be displayed in
the Monitor Diagnostic page.

Datalogic Matrix 300N Specifications

General

Type	Barcode module bar barcode readers
Sensor type	CMOS
Scanner type	1D/2D
Yaw reading angle	0 - 24 °
Optical sensor resolution	1024 pixels
Linear (1D) barcodes supported	-
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, MaxiCode, Micro QR Code, QR Code
Input voltage	10 - 30 V
Power consumption (typical)	5 W
Connectivity technology	Wired
Certification	AIM DPM, ISO/IEC 15415, ISO/IEC 15416, ISO/IEC 16022, ISO/IEC 18004, AS9132A
Product color	Blue, Metallic
Housing material	Aluminium, Plastic
International Protection (IP) code	IP67
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 50 °C

Weight and Dimensions

Depth	54 mm
Width	75 mm
Height	62 mm
Weight	238 g