Internal Network Configurations
Product Reference Guide 163
3. Now save them to a new Slave specific application job
1
.
Figure 91 - Saving Multidata Configuration to Slave 1
Repeat this procedure for each Slave device until the entire network is
configured.
The following screenshots show the pass-through configuration settings for the
t
hree devices in the example in "ID-
NET Multidata Network (Pass-Through)" on
page 90.
1. If
Save on Slave Device
was selected when saving the Master configuration, an application job
with the same name (but with all Slave specific configuration parameters), has been saved to
the Slaves. No parameters have been cloned from the Master. There are no common parame
-
ters managed by the Master for Multidata configurations.
To Next Page
Loading...
