Software Configuration
186
Matrix 300N
The Slaves must always be configured with the same network baud rate as the
Master for correct functioning including performing Backup and Restore
procedures.
Backup and Restore functions cannot be interrupted once started.
To perform
Backup
:
1. Make sure the Write Protection switch on the BM100 is unlocked.
2. Select the Backup item from the Extended menu and press the Enter key.
3. When the procedure is complete a message appears on the display showing
the results (Backup OK 1 File Saved or an error message).
4. Set the Write Protection switch to locked.
To perform
Restore
:
1. Select the Restore item from the Extended menu and press the Enter key.
2. When the procedure is complete a message appears on the display showing
the results (Restore OK 1 File Restored or an error message).
To Next Page
Loading...
