NOTE
Step 6 - Device Configuration
Product Reference Guide 15
5. Click on the Start Automatic Setup button. The following window is dis-
played:
6. Select the correct reading conditions: Static or Dynamic Tuning, 1D or 2D
code, Include Image Filtering (to find the best decoding condition).
7. Click Start to begin the procedure. The re
ader begins acquiring images. At
the end of the procedure the Status: Completed message appears. You can
Close the Automatic Setup window.
If the image display area is too dark to see the images being captured, you can drag
the Gain and Exposure Time sliders (circled in red in the figure above) to the right to
increase visibility. This will not affect Automatic Setup.
To Next Page
Loading...
