Dell Precision 7875 Tower - Page 163

Table 39. System setup options—Storage menu
Storage
SATA/NVMe Operation
SATA/NVMe Operation Set the operating mode of the integrated storage device controller.
By default, the ACHI/NVMe option is enabled.
Storage interface
Port Enablement This page allows you to enable the onboard drives.
By default, the all options are enabled.
SMART Reporting
Enable SMART Reporting Enable or disable Self-Monitoring, Analysis, and Reporting Technology
(SMART) during system startup.
By default, the Enable SMART Reporting option is not enabled.
Drive Information
SATA-0
Type: Displays the type information of the system.
Device: Displays the device information of the system.
SATA-1
Type: Displays the type information of the system.
Device: Displays the device information of the system.
SATA-2
Type: Displays the type information of the system.
Device: Displays the device information of the system.
SATA-3
Type: Displays the type information of the system.
Device: Displays the device information of the system.
SATA-4
Type: Displays the type information of the system.
Device: Displays the device information of the system.
M.2 PCIe SSD-0
Type: Displays the type information of the system.
Device: Displays the device information of the system.
M.2 PCIe SSD-1
Type: Displays the type information of the system.
Device: Displays the device information of the system.
MCIO PCIe SSD-0
Type: Displays the type information of the system.
Device: Displays the device information of the system.
MCIO PCIe SSD-0
Type: Displays the type information of the system.
Device: Displays the device information of the system.
Enable MediaCard
Secure Digital (SD) Card Enable or disable the SD card.
By default, the Secure Digital (SD) Card option is enabled.
Secure Digital (SD) Card Read-Only Mode Enable or disable the SD card read-only mode.
By default, the Secure Digital (SD) Card Read-Only Mode option is not
enabled.
BIOS Setup 163