9. Align the screw holes on the solid state drive heat sink with screw holes on the UltraSpeed Quad card.
10. Tighten the four captive screws that secure the solid state drive heat sink in place.
11. Close the fan shroud and press until it clicks in place.
NOTE: The UltraSpeed Duo card can support four M.2 2280 solid state drives. Repeat step 1 to step 10 to install the
solid state drive into the second slot.
Next steps
1. Install the UltraSpeed Quad card.
2. Install the side cover.
3. Follow the procedure in After working inside your computer.
Installing the UltraSpeed Quad M.2 2230 solid state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of theUltraSpeed Quad M.2 2230 solid state drive and provide a visual representation
of the installation procedure.
88
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
