OPERATION
If this item is set to Automat , you must enter a ”Retraction Off Set”, which is used ic
”Retraction Offset” is recommended to be –0.5.
Retraction Offset
be set in
s been set to “Automatic”, “Retraction Offset” must be set in
t of a single setting to the factory default.
When the default button is reversed press the setting you wish to reset.
If the default button is accidentally pressed, press it again to deselect the button.
to fine-tune the ribbon pull back.
Retraction Length
This menu being displayed on the screen depends on how “Retraction Type” has
been set.
If “Retraction Type” has been set to “off”, the field is hidden.
If “Retraction Type” has been set to “Manual”, “Retraction Length” must
this field.
If “Retraction Type” ha
this menu.
(2) Default
The default button allows the rese
To do this press the “default” button once.
Notice that the button is now reversed
27864 Issue 1January 2008 (157)
To Next Page
Loading...