MAINTENANCE & FAULT FINDING
Error No.
Error text Action
11 Speed Too Low to print.
is above 50
rint cycle.
The web speed is too slow
Ensure that the web speed
mm/sec during the entire p
12 Y-offset too short me parts of
educe speed.
The Y-offset it to short. So
the print out may be missed.
Increase the Y-offset or r
13 Ribbon Alarm The ribbon is broken or there is no
eck remaining
sive
iss
unwinding
ibbon alarm
lso be triggered
sensor. If the
fixed intervals
ribbon
ay be damaged.
bon
sensor.
more ribbon left. Ch
ribbon.
In some scenarios an exces
retraction (or mechanical m
adjustment) can cause the
dancer arm to touch the r
sensor.
A ribbon alarm can a
by the ribbon warning
ribbon alarm comes in
(like every 5 prints) the
warning sensor m
Use diagnostics to check rib
warning and ribbon alarm
Check remaining ribbon.
20 Init: print head voltage measures the voltage
ltage is too
or comes up.
eck for short cuts in the cable that
f.
YTHING
qualified
A security system
to the print head. If the vo
high or to low this err
Ch
end in the print head itsel
DO NOT REPLACE AN
YOURSELF - call for
personnel.
21 wer supply e voltage supplied by the interval
uring start. If
e voltage is out of specification
es up.
nection.
Init: Main po Th
power supply is tested d
th
(46V±6V) this error com
Check the power con
22: Init: PWM valve Reserved
23: Init: VPP voltage Reserved
28:
Empty Label There is no field in the label or the
field does not contain any data.
Redesign the label.
(
216) 27864 Issue 1 January 2008
To Next Page
Loading...
Need help?
General
