MAINTENANCE & FAULT FINDING
The print head carries does not move
Only IM5
d linear
e Print head. If
head does not drive, check the
e condition of the drive belt
onnections
linear slide.
With the power to the unit turned off, is
ve along the
the fault persists, replacement the
stepper board VEY0031 may be
required.
A stepper motor, drive belt an
slide are used to move th
the
following:
Check th
and drive pulleys.
Are the stepper motor c
correct?
Check the condition of the
the Print head free to mo
slide?
If
Cassette rollers alignment te the
n the
ibbon that
visually note
g to one
bably the
tte rollers that are out of alignment.
If alignment is only slightly out, you
may be able to gently knock the roller
back into alignment. Otherwise the
cassette roller will need to be replaced.
This is better done at DOMINO repair
department.
Pick up the cassette and rota
ribbon by hand by winding o
rewind spool. Look at the r
goes around the rollers and
whether the ribbon is pullin
side. If this is the case it is pro
casse
27864 Issue 1January 2008 (249)
To Next Page
Loading...
Need help?
General
