20140704#1.0 EBS Ink Jet Systeme
67
In the Position sheet tab:
The Initial distance parameter defines the distance from the point where the
print release button is pressed to the point where printing of a print should
start. The distance is given as a number of millimeters, and it is measured
after the trigger has been pressed and before printing starts. It enables you to
adjust the print position in relation to the beginning of the article.
The Print spacing parameter defines the distance between the beginnings
of prints that are made repeatedly (Printout repetition >1). The distance is
given as a number of millimeters.
NOTE: If the distance set with the Print spacing parameter is smaller than
the print length, prints are printed one just after another.
The Flip vertical parameter defines the mode of printing in the vertical
direction: normal or turned upside down. It can be useful when an article to
be labeled is turned.
Normal print
Reversed print
The Flip horizontal parameter can be useful if you need to label articles
from right to left or if you print on transparent materials and the prints
should be legible from the opposite side.
Normal print ,
To Next Page
Loading...
