66
EBS Ink Jet Systeme 20140704#1.0
Intensity is physically constrained by the real speed at which the head can
print – it means that when the intensity is too high for a given printing
speed, the printer signals an error with an audible signal (provided that an
appropriate warning is set – see Sound Settings (p. 23)), and higher
intensity also limits the printing speed.
The parameter is also available on the main screen– see Operating Touch
Screen (p. 12), item R.
The Resolution parameter impacts on the visibility of the project
characters after they have been printed. It decides on print resolution,
which is given as a number of rows/meter. In other words, a change in the
width of characters printed and in the length of the entire project are the
visual effects of a change in the setting of the Resolution parameter.
This parameter is available also on the main screen – see Operating
Touch Screen (p. 12), item S.
The printer is equipped with a practical tool, Measure, which is designed
for adjustment of print resolution to the length of the surface to be labeled –
see page 118.
With the Pressure parameter you can adjust the force by which ink drops
are jetted, to the type of surface to be labeled. Lower pressure is
recommended for smooth, non-absorbing materials, and higher – for
porous, absorbing materials. Pressure settings can vary from 15 to 45 bars.
If too low pressure is set, ink may solidify on nozzles. If too high pressure is
set, irregular ink splashes (so called satellites) may occur around a print.
Detach the ink container from the printer in order to reduce the pressure of
the ink in the container, if you need to print a project where lower pressure
is set than that in the project printed before.
The Printout repetition parameter defines how many times a print is to
be re-printed after the trigger has been pressed. It allows you to make a
print repeatedly on the same article (repetition). Continuous repetition
of prints can be set for continuous articles (e.g. cables, hose, tubes,
pipes) (Printout repetition = ). The distance between successive
prints is set with the Print spacing parameter – see the Position (p.
67) sheet tab.
To Next Page
Loading...
