Patient Monitor User Manual Alarm Information
- 72 -
Message Cause
ECG ARR Learning
The QRS template building required for Arr. Analysis is
in process.
ExtremeTachy Off
Extreme Tachycardia alarm is set to Off.
ExtremeBrady Off
Extreme Bradycardia alarm is set to Off.
V-Tach Off
V-Tach alarm is set to Off.
Vent Brady Off
Vent Brady alarm is set to Off.
Key ARR Alarm Off
One of Key ARR alarms is set to Off.
SpO
2
Search Pulse
SpO
2
module is analyzing the patient signal and
searching for the pulse to compute the saturation, when
sensor is connected with patient.
NIBP Simul
NIBP Simul function is turned on.
Manual Measuring
In manual measuring mode.
Continual Measuring
In continuous measuring mode.
Auto Measuring
In automatic measuring mode.
Measurem. Canceled
Press the “Start/stop NIBP measurement” button or
shortcut key to stop the measurement.
Calibrating
During calibrating
Calibrat. Canceled
Calibration is over.
Leak. Test Running
The leakage test is in process.
Leak.Test Canceled
Pneumatic test over
Resetting
NIBP module in resetting
Please Start
NIBP module is in idle status
Done
NIBP measurement is completed.
CO
2
Standby
Switch from measuring mode to standby mode, making
the module in energy-saving status.
CO
2
Sensor Warms Up
The CO
2
module is in warm-up state
CO
2
Zero Start
CO
2
module starts zero calibration.
CO
2
Zero OK
CO
2
module completes zero calibration.
No module detected
No module is mounted in the monitor.
No module activated
No module is activated.
Loading module…
The system is loading the inserted module.
Please Press 'Zero'.
Enter the IBP zeroing menu, and zeroing is not
performed yet.
To Next Page
Loading...
Need help?
General
