Emerson FloBoss S600+ - Page 19

S600+ Instruction Manual
Revised July-2017 Installation 2-5
Figure 2-4. Remove Connector
5. Remove the top and bottom bosses from the unit housing, using a
5.5 mm (5 BA) hex wrench.
Table 2-1. Mounting Dimensions
Part
Dimensions
Display Keypad Molding
85 mm (3.35") width x 269 mm (10.59") height x 28 mm (1.10") deep
Case
84.5 mm (3.327") width x 270 mm (10.63") height x 303.8 mm (11.94")
deep
Panel Cutout
66 mm (2.6") width x 150 mm (5.9") height
Pitch Between Cases
110 mm (4.33") giving 25 mm (0.98") air gap
Max Panel Thickness
10 mm (0.39")
Access
Allow 300 mm (11.81") clearance directly behind case for maintenance
Disconnect
Here