Emerson FloBoss S600+ - Chapter 6: Webserver Access

S600+ Instruction Manual
Revised July-2017 Webserver Access 6-1
Chapter 6 – Webserver Access
In This Chapter
6.1 Defining Webserver Access ............................................................... 6-1
6.2 Accessing the S600+ .......................................................................... 6-2
6.3 Navigating the Webserver Interface ................................................... 6-5
The S600+ has an embedded webserver, which enables you to access
reports, displays, and diagnostics through the Internet. The number of
items available for viewing or modification depends on your defined
security access level (see Section 6.1).
Encryption
Mode
The S600+ ships with firmware that supports 56 bit encryption. If you
need higher levels of encryption, please contact your sales
representative.
Caution
Since this access can provide the ability to change critical S600+
settings, reserve webserver access for a corporate TCP/IP rather than
general public use.
Using any personal computer (PC) with Internet access and Microsoft
®
Windows
®
Internet Explorer
®
Version 6.0 (or greater) installed, you
can access the S600+ over its Ethernet communications ports. The
configuration file residing on the S600+ must have been created using
Config600 software version 1.4 (or greater).
Browsers
For full functionality, Remote Automation Solutions recommends you
use Internet Explorer (version 6.0 or later), although alternate web
browsers may work.
6.1 Defining Webserver Access
Using Config600 software, you must first define the specific content
each security level can view.