S600+ Instruction Manual
6-4 Webserver Access Revised July-2017
Figure 6-2. Initial Webserver Access
You then navigate through the displays using the selections on the
screen’s menu bar (see Table 6-1).
Note: The options on the hierarchy menu change as you select options
from the menu bar.
Table 6-1. Webserver Menu Bar Options
Modifies the hierarchy menu to display all available reports.
Displays all current alarms in the report display area.
Displays maintenance and current-value reports for each
defined stream.
Modifies the hierarchy menu so you can display flow rates for
each defined stream.
Modifies the hierarchy menu so you can display hourly and daily
totals for each defined stream.
Displays S600+ content as seen by the operator ID.
Modifies the hierarchy menu so you can display analog and
digital inputs and outputs.
Accesses various system settings (normally available through
the S600+ display panel) through the webserver.
Accesses tech/engineer options (normally available through the
S600 display panel) through the webserver.
Allows you to review and change various system calculations.
Displays diagnostic values for streams, stations, and other
system settings. Special features include:
Watch list: enables you to inspect or change database
variables. To change variables, enable Debug mode (from
Factory Settings on the Cold Start menu).
Debug messages: enables you to view advanced
debugging information about calculations.
Calculation blocks.
Note: Enable Debug mode only during development; disable
Debug mode when an S600+ is operational at a site.
Closes the S600+ webserver session and clears the browser’s
cache of S600+ information.