Emerson FloBoss S600+ User Manual

S600+ Instruction Manual
Revised July-2017 Startup 7-3
4. Key in your security code when the Enter Code prompt
displays.
5. Press 1 to select COLD ST, and press 1 again to confirm the
selection. The S600+ displays a SYSTEM RESTARTING –
PLEASE WAIT message.
The S600+ then performs a reset, which concludes when the
Startup menu appears.
Note: If the display has not changed after 30 seconds, power
down the S600+, wait at least five seconds, and then re-
apply power.
6. Select COLD START from the Startup menu.
7. Press 1 (to keep) or 2 (to reset) the totals.
8. Press 1 to confirm the selection. The S600+ displays the message
CONFIGURING – PLEASE WAIT.
The S600+ builds a new database using the configuration files held in
flash memory. When it completes, the S600+ Main menu displays.
7.4 Startup Menu
If the S600+ completes its start-up initialization sequence but does not
automatically warm start, the S600+ Startup menu displays (see Figure
7-1).
Note: After you modify any data in the startup menu, the S600+ may
require a power cycle.
1* WARM START
2* COLD START
3* NETWORK SETUP
4. REFLASH FIRMWARE
5. CONFIG SELECTION
8* FACTORY SETUP
Figure 7-2. Startup Menu
Startup menu options include:
Option
Description
Warm Start
Restarts a previously configured S600+ at the
point prior to being powered down.
Cold Start
Builds a new metering database on the
S600+ using the configuration files stored in
Flash memory.
Network Setup
Configures the TCP/IP, Gateway, and
Modbus addresses (see Section 7.4.1,
Network Setup).

Emerson FloBoss S600+ Specifications

General

Brand	Emerson
Model	FloBoss S600+
Category	Controller
Language	English