Extreme Networks ExtremeWare XOS Guide - Page 180

Power Over Ethernet
ExtremeWare XOS 11.3 Concepts Guide
180
The command provides the following information:
● State—Displays the port power state:
■ Disabled
■ Searching
■ Delivering
■ Faulted
■ Disconnected
■ Other
■ Denied
● PD’s power class—Displays the class type of the connected PD:
■ “-----”: disabled or searching
■ “class0”: class 0 device
■ “class1”: class 1 device
■ “class2”: class 2 device
■ “class3”: class 3 device
■ “class4”: class 4 device
● Absent—Displays the number of times the port was disconnected.
● InvSig—Displays the number of times the port had an invalid signature.
● Denied—Displays the number of times the port was denied.
● Over-current—Displays the number of times the port entered an overcurrent state.
● Short—Displays the number of times the port entered undercurrent state.
Following is sample output from this command:
STATISTICS COUNTERS
Port State Class Absent InvSig Denied OverCurrent Short
3:1 delivering class3 0 0 0 18 0
3:2 delivering class3 0 0 0 0 0
3:3 searching class0 0 0 0 0 0
3:4 searching class0 0 0 0 0 0
3:5 searching class0 0 0 0 0 0
3:6 searching class0 0 0 0 0 0
3:7 searching class0 0 0 0 0 0
3:8 searching class0 0 0 0 0 0
3:9 searching class0 0 0 0 0 0
3:10 searching class0 0 0 0 0 0