Extreme Networks ExtremeWare XOS Guide User Manual

Event Management System/Logging
ExtremeWare XOS 11.3 Concepts Guide
201
Components and Conditions
The event conditions detected by ExtremeWare XOS are organized into components and
subcomponents. To get a listing of the components and subcomponents in your release of ExtremeWare
XOS, use the following command:
show log components {<event component>} {version}
For example, to get a list of the components and subcomponents in your system, use the following
command:
show log components
The partial output produced by the command is similar to the following:
Severity
Component Title Threshold
------------------- ---------------------------------------------- -------------
...
...
STP Spanning-Tree Protocol (STP) Error
InBPDU STP In BPDU subcomponent Warning
OutBPDU STP Out BPDU subcomponent Warning
System STP System subcomponent Error
...
...
The display above lists the components, subcomponents, and the default severity threshold assigned to
each. In EMS, you use A period (.) is used to separate component, subcomponent, and condition names.
For example, you can refer to the InBPDU subcomponent of the STP component as STP.InBPDU. On the
CLI, you can abbreviate or TAB complete any of these.
A component or subcomponent often has several conditions associated with it. To see the conditions
associated with a component, use the following command:
show log events [<event condition> | [all | <event component>] {severity <severity>
{only}}] {details}
For example, to see the conditions associated with the STP.InBPDU subcomponent, use the following
command:
show log events stp.inbpdu
The output produced by the command is similar to the following:
Comp SubComp Condition Severity Parameters
------- ----------- ----------------------- ------------- ----------
STP InBPDU Drop Error 2 total
STP InBPDU Dump Debug-Data 3 total
STP InBPDU Trace Debug-Verbose 2 total
STP InBPDU Ign Debug-Summary 2 total
STP InBPDU Mismatch Warning 2 total
The display above lists the five conditions contained in the STP.InBPDU component, the severity of the
condition, and the number of parameters in the event message. In this example, the severities of the
events in the STP.InBPDU subcomponent range from error to debug-summary.

Extreme Networks ExtremeWare XOS Guide Specifications

General

Brand	Extreme Networks
Model	ExtremeWare XOS Guide
Category	Software
Language	English