Fibocom G510 User Manual

G5/G6-Family AT Commands User Manual Page
22
of
243
4 Modem Control and Status
4.1 Modem Register Commands
The module holds certain data items in selected memory space, named Software Registers (S-registers)
and Modem Registers. Some of these registers are used as bitmaps, where one register holds more than
one data item.
All S-registers can be accessed using the S command, described in “S, Bit Map Registers”. Some
registers can also be accessed using dedicated commands, detailed below.
4.1.1 V, Module Response Format
This command determines the response format of the data adapter and the contents of the header and
trailer transmitted with the result codes and information responses. This command also determines
whether the result codes are transmitted in a numeric or an alphabetic ("verbose") form. The text portion
of information responses is not affected by this setting.
The following table shows the effect that setting this parameter has on the format of information text and
result codes.
V0
V1
Information Responses
<ATV0><cr><lf>
<ATV1><cr><lf>
0 - "OK"
1 - "CONNECT"
2 - "RING"
3 - "NO CARRIER"
4 - "ERROR"
5 - "NO DIALTONE"
6 - "BUSY"
7 - "NO ANSWER"
8 - “NOT SUPPORT”
9 - “INVALLID COMMAND LINE”
10 - “\r\n”
<numeric code><cr>
<verbose code><cr><lf>
Command
Syntax
Response/Action
Remarks
Set
ATV<value>
OK
The Set command sets the format

Fibocom G510 Specifications

General

Brand	Fibocom
Model	G510
Category	Modem
Language	English