Fibocom G510 - MHUP, Module Hung up Call

G5/G6-Family AT Commands User Manual Page
60
of
243
AT+MDC=?
+MDC: (0-1)
OK
AT+MDC=1
OK
ATD<number>;
OK
CONNECT
AT+MDC?
+MDC: 1
OK
AT+MDC=0
OK
ATD<number>;
OK
OK
AT+MDC?
+MDC: 0
OK
5.1.17+MHUP, Module Hung UP call
This command hung up a specific call or all calls, and reports a specific disconnect cause to the NW.
Command
Syntax
Response/Action
Remarks
Set
AT+MHUP=<
cause>[,<call
_id>]
OK
or:
+CME ERROR: <err>
Test
AT+MHUP=?
+MHUP:
(1,16,17,18,27,31),(0-7)
OK
Show list of supported <cause>'s
and list of supported <call_id>'s.
The following table shows the +MHUP parameters.
<Parameter>
Description
<cause>
Cause description, send to the NW in the "disconnect" message.
1 "Unassigned (unallocated) number"