Fibocom G510 - 5.1.5 A, Answer Incoming Call

G5/G6-Family AT Commands User Manual Page
43
of
243
Single (or MTPY) Active and Single (or MTPY) Held &
Waiting call
Single (or MTPY) Active released
Example:
RING //Incoming call
RING //Incoming call
ath //Hang-up incoming call
NO CARRIER
OK //Incoming call has been terminated - user determined user busy
RING
ata
OK //Voice call connected
ath //Hang-up connected call
NO CARRIER
OK //Active call has been hung-up - terminated
(... Active multi party call, with 3 numbers …)
ath
NO CARRIER
NO CARRIER
NO CARRIER
OK
atd035659260;
OK
ath //Terminate MO voice call while placed
NO CARRIER
OK
5.1.5 A, Answer Incoming Call
This command answers an incoming VOICE call after a RING/+CRING indication is sent to the terminal.
If the incoming call is answered (connected), the Module sends a CONNECT notification to the terminal.
If the MT call fails, the possible notifications are:

NO CARRIER - Connection Failure
 ERROR - General Failure
Note: A waiting call (an incoming call while a call is in progress) is announced by +CCWA rather than
RING. A waiting call can be answered only if it is a voice call. The waiting voice call should be answered