Fibocom G510 - MIPRUDP, Receive Data from UDP Protocol Stack; MIPRTCP, Receive Data from TCP Protocol Stack

AT Commands User Manual Page
212
of
243
AT+MIPFLUSH=2 //Socket number 2 was previously opened using the +MIPOPEN
command
+MIPFLUSH: 2
OK
AT+MIPFLUSH=5
ERROR
AT+MIPFLUSH?
+MIPFLUSH: 1, 2
OK
13.1.9+MIPRUDP, Receive Data from UDP Protocol Stack
This unsolicited event is sent by the Module to the terminal when data is received from the UDP protocol
stack.
Set Command Event
+MIPRUDP: <Source_IP>,<Source_Port><socket_ID>,<Left>,<Data>
The following table shows the +MIPRUDP parameters.
<Parameter>
Description
Source_IP
IP of the source
Source_Port
Port of the source
Socket_ID
1,2,3,4 - Number of valid sockets.
Left
Size of received Data still left in protocol stack.
Data
Data string received with 0-F hexadecimal digits. String ends with a
<CR>.
Example:
+MIPRUDP: 172.16.3.135,222,2,0,44444444
13.1.10 +MIPRTCP, Receive Data from TCP Protocol Stack
This unsolicited event is sent by the Module to the terminal when data is received from the TCP protocol
stack.
Set Command Event
+MIPRTCP: <socket_ID>,<Left>,<Data>