Fibocom G510 - 4.1.8 Z, Reset to Default Configuration; 4.1.9 &W, Store User Profile

G5/G6-Family AT Commands User Manual Page
28
of
243
Example:
AT&F?
&F: 0
OK
4.1.8 Z, Reset to Default Configuration
This command drops the current call, and resets the values to default configuration.
Command
Syntax
Response/Action
Remarks
Set
ATZ<value>
OK
or:
+CMS ERROR:
<err>
Read
The Read command for Z is not defined,
and therefore is not supported by the
Module. The Module returns an error.
Test
The Test command for Z is not defined, and
therefore is not supported by the Module.
The Module returns an error.
The following table shows the Z parameters.
<Parameter>
Description
<value>
0 Set to user profile 0
The default value is 0.
Example:
ATZ0
OK
4.1.9 &W, Store User Profile
This command saved the active profile to one of two user profiles.
Note: The user must power off the module in regular process. Otherwise, this command cannot be in