Fibocom G510 - CLIP, Calling Line Identification; CLIP Indication

G5/G6-Family AT Commands User Manual Page
46
of
243
+CRING: VOICE
+CRING: VOICE
ath
NO CARRIER
OK
5.1.7 +CLIP, Calling Line Identification
This command controls the Calling Line Identity (CLI) presentation indication to the terminal when an
incoming call is detected by the Module.This command allows the user to query the provisioning status of
the CLI by the network and by the Module. The command also allows the user to enable/disable the CLI
presentation by the Module to the terminal. The +CLIP indication information varies depending on what is
provided by the network and what information is stored in the Module phone book.
Command
Syntax
Response/Action
Remarks
Set
AT+CLIP=[<n>]
OK
or:
+CME ERROR:
<err>
The Set command enables or disables the
presentation of the CLI indication from the
Module to the terminal. Note: The Set
command does not address the network.
Read
AT+CLIP?
+CLIP: <n>, <m>
OK
The Read command returns the +CLIP
enable/disable state in the Module as well as
in the network provisioning state of the CLI
presentation.
Test
The Test command returns the Set command
options (0,1).
5.1.8 +CLIP Indication
When the CLI presentation indication is enabled by the Module (<n>=1), this unsolicited indication is sent
to the terminal after the RING indication.
+CLIP: <number>,<type>[,<subaddr>,<satype>[[,<alpha>] [,<CLI validity>]]]
The following table shows the +CLIP parameters.
<Parameter>
Description
<n>
Enables/disables the CLI presentation indication after the ring indication:
0 Disable CLI presentation
1 Enable CLI presentation