Fibocom G510 - CHUP, Hang up Call

G5/G6-Family AT Commands User Manual Page
59
of
243
5.1.15 +CHUP, Hang up Call
This command causes the Module to hang up the current GSM call.
Command
Syntax
Response/Action
Remarks
Set
+CHUP
OK
or:
+CME ERROR
<err>
The Set command hangs up the current
GSM call.
5.1.16 +MDC, Selection of Desired Message to Be Displayed Upon
Connection of a Voice Call
This AT command enables you to select the desired messages to be displayed upon connection of a voice
call with a remote party. The OK and CONNECT messages are available.
Command
Syntax
Response/Action
Remarks
Set
+MDC=<
mode>
OK
or:
+CME ERROR:
<err>
The Set command selects which of the
supported messages will be displayed upon
connection of a voice call.
<mode> Command Parameters:
0 - Display OK on voice call connection
1 - Display CONNECT on voice call
connection
Default Values:
Power Up - As previously saved in NVM
FLEX bit
0 - Before Set command is first used
Read
+MDC?
+MDC: <mode>
OK
The Read command should return the
current selection of <mode>.
Test
+MDC=?
+MDC: (list of
supported
<mode>s)
OK
The Test command returns the possible
<mode> values.
Example: