Fibocom G510 - CSDH, Show Text Mode Parameters

G5/G6-Family AT Commands User Manual Page
91
of
243
OK
AT+CMGR=6
+CMGR: "STO UNSENT","15820447141","",129,17,0,0,167,"+8613800755500",145,3
ABC
OK
7.1.6 +CSDH, Show Text Mode Parameters
This command controls whether detailed header information is shown in text mode result codes.
Command
Syntax
Response/Action
Remarks
Set
+CSDH=[<show>
]
OK
or:
+CMS ERROR: <err>
The set command controls whether
detailed header information is shown
in text mode result codes.
Read
AT+CSDH?
+CSDH: (<show>)
OK
The read command returns the
current <show> parameter value.
Test
AT+CSDH=?
+CSDH: (list of supported
<show>s)
OK
The following table shows the +CSDH parameters.
<Parameter>
Description
<show>
0 - Means do not show header values defined in commands +CSCA and +CSMP
(<sca>, <tosca>, <fo>, <vp>, <pid> and <dcs>) nor <length>, <toda> or <tooa> in
+CMT, +CMGL, +CMGR result codes for SMS- DELIVERs and SMS-SUBMITs in text
mode; for SMS-COMMANDs in +CMGR result code, do not show <pid>,<mn>, <da>,
<toda>, <length> or <cdata> (default).
1 - Means show the values in result codes.
Example:
AT+CSDH=?
+CSDH: (0-1)
OK
AT+CSDH?
+CSDH: 0