Fibocom G510 User Manual

G5/G6-Family AT Commands User Manual Page
172
of
243
The data format is in hex. As the input command can only be character, so here use two characters to
indicate one hex number. E.g.: “35” means 0x35. Module will change the format internally.
Command
Syntax
Response/Action
Remarks
Set
AT+UARTSEND=
<source>,<data>
OK
Or:
+CME ERROR: <err>
Used to send data to
UART2.
Test
AT+UARTSEND=
?
+UARTSEND:
<source>,<data>
OK
or
ERROR
Return supported values
The following table shows the +UARTSEND parameters.
<Parameter>
Description
<source>
1 (For internal reason 1 indicates UART1 here)
2(For internal reason 2 indicates UART2 here)
<data>
0-F (The data should be wrap up with “”, and the valid character is
0-F)
Example:
AT+UARTSEND=2,”30313233”
OK //UART2 will output “0123”
AT+UARTSEND=?
+UARTSEND: (2),(“data”)
10.2.4UART2 use for AT Command
When use for AT command. It supports the following AT commands only:
CFSN
CGMI
CGMM
CGMR
CGREG
CGSN

Fibocom G510 Specifications

General

Brand	Fibocom
Model	G510
Category	Modem
Language	English