Fibocom G510 User Manual

G5/G6-Family AT Commands User Manual Page
24
of
243
Example:
ATQ0
OK
ATQ?
Q: 0
OK
ATQ4
ERROR
ATQ1 //No response because result codes are suppressed.
ATQ4 //No response because result codes are suppressed.
4.1.3 E, Command Echo
This command defines whether input characters are echoed to output. If so, these characters are echoed
at the same rate, parity and format at which they were received.
Command
Syntax
Response/Action
Remarks
Set
ATE<value>
OK
or:
+CME ERROR: <err>
The Set command sets whether or
not to echo characters.
Read
ATE?
<value>
OK
The Test command for E is not
defined by ITU, and therefore is not
supported by the module. The
module returns an error.
The following table shows the E parameters.
<Parameter>
Description
<value>
000 Does not echo characters
001 Echoes characters
The default value is 1.
Example:
ATE?
001
OK

Fibocom G510 Specifications

General

Brand	Fibocom
Model	G510
Category	Modem
Language	English