Fibocom G510 User Manual

G5/G6-Family AT Commands User Manual Page
191
of
243
Example:
AT+CGQMIN=?
+CGQMIN: "IP",(1-2),(0-4),(0-5),(0-9),(0-18)
OK
AT+CGQMIN?
+CGQMIN: 1,2,4,3,9,10
+CGQMIN: 2,2,4,3,9,10
OK
12.2.4+CGQREQ, Quality of Service Profile (Requested)
This command enables the terminal to specify a Quality of Service Profile that is used when the ME sends
an Activate PDP Context Request message to the network.
Command
Syntax
Response/Action
Remarks
Set
AT+CGQREQ=<
cid>[,<preceden
ce>[,<delay>[,<r
eliability>[,<pea
k>[,<mean>]]]]]
OK
or:
+CME ERROR: <err>
The Set command specifies a profile
for the context identified by the (local)
context identification parameter,
<cid>. As this is the same parameter
that is used in the +CGDCONT
command, the +CGQREQ command
is effectively an extension of the
+CGDCONT command. The QoS
profile consists of a number of
parameters, each of which may be
set to a separate value. A special
form of the Set command,
+CGQREQ= <cid>, causes the
requested profile for context number
<cid> to become undefined.
Read
AT+CGQREQ?
+CGQREQ:
<cid>,<precedence>,<dela
y>,<reliability>,<peak>,
<mean>
OK
The Read command returns the
current settings for each defined
context.
Test
AT+CGQREQ=?
+CGQREQ:
<PDP_type>,(list of
The Test command returns values
supported as a compound value. If

Fibocom G510 Specifications

General

Brand	Fibocom
Model	G510
Category	Modem
Language	English