Fibocom G510 - Page 190

G5/G6-Family AT Commands User Manual Page
190
of
243
command. The QoS profile consists
of a number of parameters, each of
which may be set to a separate
value.
Read
AT+CGQMI
N?
+CGQMIN:
<cid>,<precedence>,<delay>,<relia
bility>,<peak>,<mean>[<CR><LF>
+CGQMIN:
<cid>,<precedence>,<delay>,<relia
bility.>,<peak>,<mean>[...]]
OK
or:
+CME ERROR: <err>
The Read command returns the
current settings for each defined
context.
Test
AT+CGQMI
N=?
+CGQMIN: <PDP_type>, (list of
supported <precedence>s), (list of
supported <delay>s), (list of
supported <reliability>s), (list of
supported <peak>s), (list of
supported <mean>s)
OK
or:
+CME ERROR: <err>
The Test command returns the
parameter value ranges for each
<PDP_type>
The following table shows the +CGQMIN parameters.
<Parameter>
Description
<cid>
A numeric parameter that specifies a particular PDP context definition.
The value is from 1 to 2.
<precedence>
A numeric parameter that specifies the precedence class.
<delay>
A numeric parameter that specifies the delay class.
<reliability>
A numeric parameter that specifies the reliability class.
<peak>
A numeric parameter that specifies the peak throughput class.
<mean>
A numeric parameter that specifies the mean throughput class.